Canon Pixma MP560 Service Manual page 25

Timing slit 15
disk feed
film
Print head 1
Wireless 15
LAN board
ass'y
screws)
(5) Left cover (2 screws)
(6) Document cover /
Scanner unit
(7) Main case (3 screws)
- Upon contact with the film,
wipe the film with ethanol.
- Confirm no grease is on the
film. (Wipe off any grease
thoroughly with ethanol.)
- Do not bend the film.
(1) Cassette unit
(2) Operation panel cover /
Right guide
(3) Right cover (2 screws)
(4) Operation panel unit (7
screws)
(5) Left cover (2 screws)
(6) Document cover /
Scanner unit
(7) Main case (3 screws)
(8) Wireless LAN board
ass'y
correction in the service
mode (only when
uneven printing or
streaks appear on
printouts after
replacement).
[See 4-2. Service
Mode, for details.]
After replacement:
1. Perform print head
alignment in the user
mode.
After replacement:
1. Reset the LAN
settings in the user
mode.
2. Print the EEPROM
information in the
service mode to
confirm that the WL-
LAN MAC address is
properly updated.
[See 4-2. Service
Mode, for details.]
22 / 64
- Service test print
- EEPROM
information print
- Service test print