Canon Pixma MP560 Service Manual page 23

Platen unit 25
Spur unit 25
Purge drive 25
system unit
plate) removal, for details.
- See 3-2. Pars Replacement
Procedures, (10) Engine
unit reassembly, for details.
(1) to (9) Same as the logic
board ass'y
(10) Front door link (2
screws)
(11) PictBridge board (2
screws)
(12) Bottom case unit (7
screws)
(13) Right chassis (3
screws)
(14) PE sensor board
(15) ASF unit (3 screws)
(16) Carriage rail
(17) Carriage unit (3 screws)
(18) Spur unit
(19) Platen unit (3 screws)
(1) to (9) Same as the logic
board ass'y
(10) Front door link (2
screws)
(11) PictBridge board (2
screws)
(12) Bottom case unit (7
screws)
(13) Right chassis (3
screws)
(14) PE sensor board
(15) ASF unit (3 screws)
(16) Carriage rail
(17) Carriage unit (3 screws)
(18) Spur unit
- DO NOT contact the spur
edges.
(1) to (20) Same as the
switch system unit and the
paper feed motor
(21) Purge drive system unit
- See 3-2. Pars Replacement
Procedures, (9) Purge drive
system unit (right plate)
and switch system unit (left
plate) removal, for details.
After replacement:
1. Perform LF / Eject
correction in the
service mode (only
when uneven printing
or streaks appear on
printouts after
replacement).
[See 4-2. Service
Mode, for details.]
After replacement:
1. Check the ink system
function.
2. Perform LF / Eject
correction in the
service mode (only
when uneven printing
or streaks appear on
printouts after
replacement).
[See 4-2. Service
Mode, for details.]
After replacement:
1. Confirm the purging
operation and the
machine operation.
[See 4-5. Verification
After Repair
details.]
20 / 64
- EEPROM
information print
- Service test print
- EEPROM
information print
- Service test print
- Service test print
for