Canon Pixma MP560 Service Manual page 12

Hide thumbs Also See for Pixma MP560:
Table of Contents

Advertisement

The connected
[2001]
digital camera or
digital video
camera does not
support Camera
Direct Printing.
The remaining ink
[1683] U130 The remaining level
amount unknown
(raw ink present).
Ink tank not
[1684] U140 The following ink
recognized.
Ink tank not
[1682] U150 The following ink
recognized.
---
The device may be
incompatible.
Remove the device
and check the
manual supplied
with the connected
device.
of the following ink
cannot be correctly
detected. Replace
the ink tank.
tank cannot be
recognized.
(Applicable ink tank
icon)
tank cannot be
recognized.
(Applicable ink tank
icon)
9 / 64
becomes full, no further
printing can be
performed unless the
applicable ink absorber
is replaced.
Remove the cable
between the camera and
the machine.
An ink tank which has
once been empty is
installed. Replace the
applicable ink tank with
a new one. Printing
with a once-empty ink
tank can damage the
machine.
To continue printing
without replacing the
ink tank(s), press the
Stop button for 5 sec. or
longer to disable the
function to detect the
remaining ink amount.
After the operation, it is
recorded in the machine
EEPROM that the
function to detect the
remaining ink amount
was disabled.
A non-supported ink
tank (an ink tank that is
sold in a different
region from where the
machine was
purchased) is installed
(the ink tank LED is
turned off). Install the
supported ink tanks.
A hardware error
occurred in an ink tank
(the ink tank LED is
turned off). Replace the
ink tank(s).
- Ink tank
- Spur unit
- Ink tank
- Ink tank

Advertisement

Table of Contents
loading

Table of Contents