Eeprom Parameter Values Adjustments (Okipage 6Ex); Maintenance Modes And Functions; User Maintenance Mode; System Maintenance Mode - Oki OKIPAGE 6e Service Manual

4.2

EEPROM Parameter Values Adjustments (OKIPAGE 6ex)

This chapter describes the adjustment necessary when replacing a part. The Adjustment is made
by changing the parameter value set in the EEPROM on the Main Control PCB. In the OKIPAGE
6ex, this is set by the key operation from the operator panel. This printer has three kinds of
maintennace modes, and it is necessary to select one of the modes when replacing the part. In
the OKIPAGE 6e, this is set using the software Maintenance Utility described in Appendix D.
4.2.1

Maintenance Modes and Functions

User Maintenance Mode

This mode is being released to end-users, but it is rarely accessed.
To enter into the user maintenance mode, turn the POWER switch on while holding the
MENU key down.
Function
There are following five functions:
• Hex dump
• Menu reset
• X-adjust / Y-adjust
Detailed descriptions of these functions are provided in Appendix C, DIAGNOSTICS
TEST.

System Maintenance Mode

Note: This mode is used only by service persons and it should not be released to the end-
users.
To enter into the system maintenance mode, turn the POWER switch on while holding the
RECOVER key down.
Function
There are following five functions:
• Page count display
• Page count printing enable/disable
• Rolling ASCII continuous printing
• HIPER-W
• SIDM
Detailed descriptions of these functions are provided in Appendix C, DIAGNOSTICS
TEST.
Adjustments
• Drum counter reset
• Operator panel menu disable
• EEPROM reset
ENABLE/DISABLE
ENABLE/DISABLE
4 - 2 OKIPAGE 6e/6ex
Service Manual, P/N 59276401