Oki OKIPAGE 6e Service Manual page 236

JAM Error
Paper Inlet Jam
• Does paper jam at the inlet when the power is turned on?
• NO When the paper is fed in, does the paper inlet jam occur?
• NO Are the roller-A and roller-B rotating?
• NO Is the pulse motor turning?
• NO Is the connector cord being connected properly?
• YES Check the coil resistance (approx. 32Ω) of the pulse motor.
Is is normal?
• YES Replace the OLEV-11 PCB.
Multi-Purpose Feeder
• YES Is the paper located above the sensor plate (Inlet)?
• YES Remove the paper.
• NO Is the sensor plate (Inlet) operating normally?
• NO Replace the sensor plate (Inlet).
• YES Replace the power supply board or inlet sensor.
• YES Is the paper being fed to above sensor plate (Inlet)?
• YES Is the sensor plate (Inlet) operating normally?
• NO
• YES Clean the Inlet sensor on the power supply board or replace the
power supply board or Inlet sensor.
• NO Replace the roller-A or roller-B.
• YES Set the paper properly.
• YES Replace planet gear.
• NO Connect the connector cord properly.
• NO Replace the pulse motor.
Replace the sensor plate (Inlet).
E - 19 OKIPAGE 6e/6ex
Service Manual, P/N 59276401