Print Voids - Oki OKIPAGE 6e Service Manual

Print Voids

6
• Is the contact plate of the transfer roller in proper contact with the power supply board (see
Fig. 6-5)?
• No
• Yes Replace the transfer roller.
• Has the problem been removed.
• Yes
• No Are the contacts of the toner supply roller, developing roller, image drum and
charging roller in proper contact with the contact assy (see Fig. 6-4
)?
E
• No
• Yes Replace the image drum unit.
• Has the problem been removed?
• Yes
• No Is the LED head being installed properly (check connector CN4 (OKIPAGE 6e) or
HEAD1, HEAD2 (OKIPAGE 6ex) on the Main Control PCB and PC Connector on
the LED head)?
• No
• Yes Replace the LED head or the head cable.
• Has the problem been removed?
• Yes End
Note: After replacing the LED head, set the printer in the engine maintenance mode
• No Replace the Main Control PCB or power supply board.
Troubleshooting
Adjust the contact plate so that it touches the power supply board and the
shaft of the transfer roller properly.
End
Adjust the contacts so that they touch the contact assy properly.
End
Note: After replacing the image drum unit, set the printer in the user
maintenance mode by turning the power on while pressing the MENU
key, and reset the drum counter (see User's Manual).
Install the LED head properly.
by turning the power on while pressing the FORM FEED and ENTER keys.
Set the LED head drive time (see 4.2).
6 - 39
A B
, , C ,
OKIPAGE 6e/6ex
Service Manual, P/N 59276401
D
,