Shure DDS 5900 User Manual page 23

Audio Recorder
Connect an audio recorder to the analog outputs of the CU to record floor audio, translations, or a specific set of
microphones. Use the browser interface to select groups and assign outputs. Connect the XLR outputs of the CU to the
inputs of an audio recorder.
Analog outputs to recorder
Mixer or DSP
Connect an mixer to the CU analog outputs to control individual microphone volume or equalization. Use the browser
interface to buss units to groups and assign them to the specific output (A, B, C, or D).
To return the audio to the DDS 5900 system:
1. Connect the output of the external device to the CU Audio Input 1
2. Turn off the internal audio routing:
3. Route the Input 1 audio by selecting the Loudspeaker and turning off Out A (Group)
Analog outputs to DSP
Recording Audio
>
Audio Loudspeaker Control
DSP back to CU Input 1
Inserting a Mixer or DSP
23
>
Mic (Group A) -> Loudspeaker
Audio
Installation
>
Input/Output Control