Using Oneclick Internet; Connection Management; Menu Buttons; Radio Button - Honeywell Thor VX9 User Manual

Using OneClick Internet

If OneClick Internet is not loaded, double-tap the desktop icon to load it. If OneClick Internet is loaded but minimized to the
system tray, tap the OneClick Internet icon in the system tray to maximize it.

Connection Management

1. Launch the OneClick Internet Connection Manager and wait until the status icon is Blue indicating ready.
2. If there is a problem, verify the SIM card is installed (AT&T, T-Mobile only), the proper firmware has been loaded,
etc.
3. If Pin security is used, a popup window prompts for the SIM PIN.
4. Create a connection profile on the Settings menu.
5. Tap the Connect button.
The signal strength is indicated as well as the name of the mobile network you are using.
The screen also indicates the status of the device and the connection signal strength.

Menu Buttons

Radio Button

The Radio button allows you to switch the WWAN radio on and off to save power or to disable the radio in
instances where it is not desired (such as during airplane travel).
When the radio is switched off, the button is red. When on, it is green. If the radio is disabled by a hardware switch or if
the device is not available, the button is disabled and is light gray/white.

Statistics Button

The Statistics area provides advanced information about the connection. Values displayed are approximate.
Tap the Statistics button to enable the statistics viewing area, which is below the main area. When the statistics are
displayed, tapping the Statistics button again hides the statistics viewing area.
Data In: The amount of data received during the current connection.
Data Out: The amount of data sent during the current connection.
Total: The total amount of data transferred during the current connection.
Speed: The current data transfer rate.
Max. Speed: The maximum data transfer rate during this connection.
Time: The duration of the current connection.
5 - 103