Wireless Zero Config Utility; Switch Control To Wireless Zero Config Utility; Switch Control To Scu; Main - Honeywell Thor VX9 User Manual

Wireless Zero Config Utility

Windows XP and Windows Embedded Standard devices
Windows 7 devices
• The WZC utility has an icon in the toolbar (see above) indicating the Wireless Zero Config application is enabled but
the connection is inactive at this time (the device is not connected to a network). The WZC icon may not be visible
until control is passed to the WZC utility as described below.
• You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to connect to your network.
The Wireless Zero Configuration Utility cannot control the complete set of security features of the radio, therefore it
is recommended to use the Summit Client Utility to connect to your network..

Switch Control to Wireless Zero Config Utility

1. Select ThirdPartyConfig in the Active Profile drop down box on the Main tab.
2. A message appears that a Power Cycle is required to make settings activate properly.
3. Tap OK.
4. Restart the Thor VX9.
The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless Information control panel.
Using the options in the Wireless Zero Config panels, set up radio and security settings. There may be a slight
delay before the Wireless Zero Config icon indicates the status of the connection.

Switch Control to SCU

1. To switch back to SCU control, select any other profile except ThirdPartyConfig in the SCU Active Config drop
down list on the Main tab.
2. A message appears that a Power Cycle is required to make settings activate properly.
3. Tap OK.
4. Restart the Thor VX9.
Radio control is passed to the SCU.

Main

Start > All Programs > Summit > Summit Client Utility > Main tab
Factory Default Settings
Admin Login
Radio
Active Config/Profile
Regulatory Domain
SUMMIT
Enabled
Default
FCC, ETSI or Worldwide
5 - 37