Eap-Fast - Honeywell Thor VX9 User Manual

EAP-FAST

To use EAP-FAST, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set Auth Type to Open
3. Set WPA as follows:
• Select WPA/WPA2 to use either TKIP/AES or AES-CCMP
• Select WPA2 to use AEX-CCMP
4. Set Encryption to either TKIP/AES or AES-CCMP depending on WPA type selected
5. Set Authentication to EAP-FAST
The LCM supports EAP-FAST with automatic or manual PAC provisioning. With automatic PAC provisioning, the user
credentials, whether entered on the saved credentials screen or the sign on screen, are sent to the RADIUS server.
The RADIUS server must have auto provisioning enabled to send the PAC provisioning credentials to the Thor VX9.
For automatic PAC provisioning, once a username/password is authenticated, the PAC information is stored on the
Thor VX9. The same username/password must be used to authenticate each time. See the note below for more
details.
For manual PAC provisioning, the PAC filename and Password must be entered.
See Sign-On vs. Stored Credentials
Scroll down to enter credentials. The entries necessary are determined by the type of credentials (stored or sign on)
and the type of PAC provisioning (automatic or manual).
No entries are necessary for Sign-On Credentials with automatic PAC provisioning as the user will be prompted for the
Username and Password when connecting to the network.
5 - 26
(page 5-13) for information on entering credentials.