Initial Setup For Thor Vx9; Hardware Setup; Software; First Boot - Honeywell Thor VX9 User Manual

Initial Setup for Thor VX9

This section's instructions are based on the assumption that your new system is pre-configured and requires only accessory
installation (e.g. antenna, external keyboard and/or bar code scanner) and a power source.

Hardware Setup

In general, the sequence of events to prepare the Thor VX9 for use is:
1. Install Mounting Brackets
2. Secure Thor VX9 in Mounting Bracket Assembly.
3. Connect Vehicle Power
battery.
4. An optional screen blanking box may also be connected to the Thor VX9.
5. Connect accessories to Thor VX9, e.g. scanner, keyboard.
6. Secure all cables to the Thor VX9 with the Strain Relief Cable Clamps.
7. Turn the Thor VX9 on.
The Thor VX9 and its keyboard should be mounted in an area in the vehicle where it:
• Does not obstruct the vehicle driver's vision or safe vehicle operation.
• Can be easily accessed by anyone seated in the driver's seat.

Software

This section only applies if the Thor VX9 was ordered with an operating system. For a Thor VX9 ordered without an oper-
ating system, see Loading an Operating System on the Thor VX9

First Boot

If your Thor VX9 is shipped with a Microsoft Windows operating system pre-installed, it may be necessary to complete
the Windows licensing/registration screens when starting the Thor VX9 for the first time. To complete this information,
you may need the Microsoft Windows software/product key that was included with the Thor VX9.
If a EULA (End User Licensing Agreement) is displayed, review the EULA and indicate your acceptance. If the EULA
is declined, the Thor VX9 may reboot and display the EULA again.

Software setup

Hardware setup should be completed before starting software setup.
1. If prompted,
2. Set parameters for
3. Adjust Speaker Volume
4. Connect Bluetooth Devices
5. Complete Wireless Network Configuration
6. Set terminal emulation parameters.
2 - 2
(page 4-2) (and keyboard mounting bracket) on vehicle.
(page 4-14) to the Thor VX9. Route the power cable to a DC/DC converter then to the vehicle
Calibrate Touch Screen (page 4-8).
Power Management
(page 4-7).
(page 4-7).
(page 4-17).
(page 4-7).
(page 5-1).