Introduction; Starting Setup; Using Setup - I-Tech ITCW1010 User Manual

5.1 Introduction

The BIOS is programmed onto the BIOS chip. The BIOS setup program allows changes to
certain system settings. This chapter outlines the options that can be changed.
NOTE:
Some of the BIOS options may vary throughout the life cycle of the
product and are subject to change without prior notice.

5.1.1 Starting Setup

The AMI BIOS is activated when the computer is turned on. The setup program can be
activated in one of two ways.
1. Press the E
2. Press the E
appears on the screen.
If the message disappears before the E
again.

5.1.2 Using Setup

Use the arrow keys to highlight items, press E
PageDown keys to change entries, press F1 for help and press E
keys are shown in Table 5-1.
Key Function
Up arrow Move to the item above
Down arrow Move to the item below
Left arrow Move to the item on the left hand side
Right arrow Move to the item on the right hand side
+ Increase the numeric value or make changes
Page 50
key as soon as the system is turned on or
NTER
key when the "Press Enter to enter SETUP" message
NTER
0.
key is pressed, restart the computer and try
NTER
ICEROCK3-T10 Tablet PC
to select, use the PageUp and
NTER
to quit. Navigation
SC