Using Barcode Scanner; Figure 3-16: Barcode Scanner Program Location - I-Tech ITCW1010 User Manual

ICEROCK3-T10 Tablet PC

3.6 Using Barcode Scanner

Some models of the ITCW1010 have a barcode scanner on the top panel. To use
the barcode scanner, follow the steps below.
Check the barcode status indicator on the front panel to make sure the barcode
Step 1:
function is enabled (see Section 1.4.1). The barcode function is enabled by
default in the BIOS menu. If the barcode scanner is disabled, please go to
Chipset  PCH-IO Configuration BIOS menu to enable it (refer to Section
5.4.1).
Install EZConfig-Scanning barcode scanner program from the driver CD. Double
Step 2:
click "EZConfig-Scanning-Setup.exe" file in the "2D" folder as shown in
F igure 3-16.
5 7 3

Figure 3-16: Barcode Scanner Program Location

The EZConfig-Scanning InstallShield Wizard screen appears (Figure 3-17).
Step 3:
Follow the step-by-step instruction of the installation wizard to install the
EZConfig-Scanning barcode scanner program.
Page 25