Using Gps Evaluation Software; Figure 3-21: Barcode Information Display Area - I-Tech ITCW1010 User Manual

ICEROCK3-T10 Tablet PC

Figure 3-21: Barcode Information Display Area

3.7 Using GPS Evaluation Software

To evaluate the GPS function on the ITCW1010 models with GPS module, please
follow the instruction below.
The GPS function is enabled by default in the BIOS menu. If the GPS function is
Step 1:
disabled, please go to Chipset  PCH-IO Configuration BIOS menu to enable
it (refer to Section 5.4.1).
Install the u-center GPS evaluation software from the driver CD. Double click the
Step 2:
u-center setup file in the "GPS Module" folder as shown in Figure 3-22.
NOTE:
The u-center software installation requires network connection. Please
connect the ITCW1010 to the Internet before installation.
Page 29