Switching On The Printer; Configuring The Data Interface - Avery Dennison 64-Series User Manual

12/14 Rev. 03
 Turn on the printer using the power switch (set to position "1"). The following

 Choosing the port:
 Configuring the port:
•
•
•
•
 Setting
 Ethernet
1) Only with installed I/O interface board (option)
2) Only with installed Centronics interface board (option)
USER MANUAL

Switching on the printer

sequence of messages is displayed:
System start...
System start...
Start user prog
64-05
V 6.52
Memory: 64 MB
Flashcard: 32 MB
OFFLINE 0 JOBS
Initialisation
ONLINE 0
JOBS
If the parameter
SYSTEM PARAMETER > Turn-on mode
switches directly to offline mode when turned on.
CAUTION! - Wait at least 10 seconds between switching the device off and
on again, otherwise any modified parameter settings are not saved.

Configuring the data interface

By factory default, the 64-xx is set for data transfer via the USB interface.
Print data can also be transferred via the RS232, RS422/485
2
Centronics or Ethernet interface.
INTERFACE PARA >EASYPLUGINTERPR > Interface
RS232:
INTERFACE PARA >COM1 PORT > ...
RS232/422/485 (optional):
Ethernet:
INTERFACE PARA >NETWORK PARAM. > ...

We recommend that your network administrator configures the network
settings.
USB: no configuration required
parameters: see topic section „Info-Printouts and Parameters",
chapter "Using the Parameter Menu".
interface: Information about using it can be found in topic section
„Advanced Applications".
64-xx
The boot loader is starting.
Valid firmware recognised, program is starting.
Printer type
Version number of the printer firmware
Internal RAM (here: 64 MB)
Optional RAM on the memory medium (here: 32 MB)
– only displayed if a memory medium (memory card
or USB stick) is connected.
Offline mode
Online mode. The unit is ready for printing.
INTERFACE PARA >COM3 PORT > ...
Commissioning & Operation
is set to "Offline", the printer
1
, USB,
12