Applying Memory Cards - Avery Dennison 64-Series User Manual

12/14 Rev. 03
•
•
•
 Only use CF -cards approved by the manufacturer.
 Always wait at least 5seconds after switching off the printer before remo-
 When inserting or removing the CF card, never use force.
 Applying CF/SD
Inserting a memory 1. Switch off the printer. Wait for 5 seconds.
card 2. Insert the memory card [14A,B] with the labelled side facing to the right and
Removing a
memory card 1. Switch off the printer. Wait for 5 seconds.
2. Press the eject button slightly in a bit and release it.
3. Press the now protruding eject button completely in to eject the memory
1) SD and SDHC cards are supported with firmware version 6.35 or above.
USER MANUAL

Applying memory cards

The printer of the 64-xx series support the following memory card types:
CompactFlash (CF) Typ I [12]
1
SD [13]
SDHC
CAUTION! - Observe the following guidelines to avoid damaging the printer
or the CF card.
ving or inserting the CF card.
Flawless functioning of the memory cards is only guaranteed for the types
distributed by Avery Dennison:
Slim guide notch
Contacts
[12] CF card (article no. A7681).
[13] SD card (article no. A101465).
cards: see Plugin-card manual, topic section „Application",
chapter „CF/SD cards".
the contacts facing ahead into the card slot until it clicks into place.
CF card:
The eject button pops out.
card. Remove the memory card.
64-xx
Wide guide notch
Commissioning & Operation
17