Powering Off The Projector; Warning Indicator - Christie CAPTIVA DUW350S User Manual

3.2.2
1.
2.
3.
3.2.3
y
y
y
CAPTIVA DUW350S/CAPTIVA DHD400S User Manual
020-000816-01 Rev. 1 (07-2015)

Powering off the projector

Press the " " button on the remote control or on the control panel to
turn off the projector. The following message will be displayed on the
screen.
Press the " " button again to confirm otherwise the message will
disappear after 10 seconds. When you press the " " button for the
second time, the fan will start cooling the system and will shut down.
The cooling fans continue to operate for about four seconds for
cooling cycle and the POWER/STANDBY LED will flash Orange.
When the POWER/STANDBY LED lights solid Orange, the projector
has entered standby mode.
If you want to turn the projector back on, you must wait until the
projector has completed the cooling cycle and has entered standby
mode. Once in standby mode, press " " button to restart the
projector.
Disconnect the power cord from the electrical outlet and the projector.

Warning Indicator

When the warning indicators (see below) come on, the projector will
automatically shutdown:
"LAMP" LED indicator is lit red and if "POWER/STANDBY" indicator
flashes amber.
"TEMP" LED indicator is lit red, this indicates the projector has
overheated. Under normal conditions, the projector can be switched
back on.
"TEMP" LED indicator flashes red and if "POWER/STANDBY"
indicator flashes amber.
Unplug the power cord from the projector, wait for 30 seconds and
try again. If the warning indicator light up again, contact your service
center for assistance.
Press power key again to confirm
Section 3: iNSTallaTioN
17