Diagnostic Error Codes - IBM Eserver xSeries 335 Type 8676 Hardware Maintenance Manual And Troubleshooting Manual

Note: See "System" on page 116 to determine which components should be replaced by a field service technician.
Diagnostics panel LED
NON OPT (A PCI bus is not
operating at maximum efficiency.)

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
Note: See "System" on page 116 to determine which components should be replaced by a field service technician.
Error code/symptom
001-XXX-000 (Failed core tests)
001-XXX-001 (Failed core tests)
001-250-000 (Failed system board ECC)
001-250-001 (Failed processor board ECC) v System board
005-XXX-000 (Failed video test)
011-XXX-000 (Failed COM1 serial port test) v Check loopback plug connected to externalized serial port.
011-XXX-001 (Failed COM2 serial port test) v Check loopback plug connected to externalized serial port.
014-XXX-000 (Failed parallel port test)
015-XXX-001 (USB interface not found,
board damaged)
015-XXX-015 (Failed USB external
loopback test)
015-XXX-198 (USB device connected
during USB test)
020-XXX-000 (Failed PCI interface test)
020-XXX-001 (Failed hot-swap slot 1 PCI
latch test)
020-XXX-002 (Failed Hot-swap slot 2 PCI
latch test)
88
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
v Switch adapters, if possible. If adapters cannot be switched, they will
continue to operate at lowered efficiency and light will remain lit.
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
FRU/action
v System board
v System board
v System board
1. Video adapter (if installed)
2. System board
v Check cable from externalized port to system board.
v Check cable from externalized port to system board.
v System board
1. System board
1. Make sure the parallel port is not disabled.
2. Run the USB external loopback test again.
3. System board.
1. Remove USB devices from USB1 and USB2.
2. Run the USB external loopback test again.
3. System board.
v System board
1. PCI hot-swap latch assembly
2. System board
1. PCI hot-swap latch assembly
2. System board