Operator Information Card - IBM Eserver xSeries 335 Type 8676 Hardware Maintenance Manual And Troubleshooting Manual

Operator information card

Complete the following steps to remove the operator information card.
Note:
1. Turn off the server.
2. Disconnect all power cords and external cables from the back of the server;
3. Remove the server cover and bezel (see "Removing the cover and bezel" on
4. Remove the hard disk drive residing in the right-hand bay, if any (see "Hard disk
5. Disconnect the operator information card cables from the system board.
6. Gently pull the operator information card forward until it disengages from the
7. Disconnect the cables from the rear of the operator information card.
To replace the operator information card, connect the two cables to the rear of the
card and slide it under the tabs on the chassis until it is firmly anchored.
76
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
v Read "Installation guidelines" on page 39.
v Read the safety notices at "Safety information" on page 123.
v Read "Handling electrostatic discharge-sensitive devices" on page 126.
then, remove the server from the rack.
page 46).
drives" on page 51).
Note: The illustrations in this publication might differ slightly from your
hardware.
two tabs on the chassis, making sure that any cables that are pulled slide
smoothly.
Tabs
Operator
information card