IBM Eserver xSeries 335 Type 8676 Hardware Maintenance Manual And Troubleshooting Manual page 44

Table 5. NetWare or IntraNetWare system ODI driver teaming messages for the Ethernet controller (continued)
Message
'xxx' is not supported for AFT team.
Primary and Secondary adapters do
not match. AFT group is not created.
Requested number of Secondary
cards are not found.
Failed to create AFT group. Make
sure that the drivers for supported
adapters are loaded, primary adapter
is bound to protocols, and secondary
adapter is not bound to any protocols.
Error identifying slot numbers for the
specified board names.
Cannot unbind specified slot from
AFT group. Make sure that the slot
you specified is for the primary
adapter in an AFT group.
LAN adapter at slot nnnn (Port 0xaa)
failed to reset. Check the state of the
adapter.
AFT is not supported on this version
of NetWare.
Failed to allocate resources tags.
Please unload all LAN drivers before
unloading AFT.NLM.
34
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
Description
Explanation: A bind command has been issued for adapters not supported
by AFT.NLM.
Action: Make sure that you attempt to bind only adapters supported by
AFT.NLM.
Explanation: A bind command was entered for an adapter team that is a
combination of system and client adapters. An AFT team must be a grouping
of the same classification of adapter.
Action: Verify that all the adapters bound in a team are of the same
classification.
Explanation: The number of adapters specified in the bind command could
not be located.
Action: Verify the numbers and slot locations of the adapters to be bound. If
the problem remains, contact the network supplier.
Explanation: Binding of protocol failed. Protocol is either not bound to any
adapter or is bound to more than one adapter in the group.
Action: Ensure that the protocol is bound to only one adapter in an AFT
team.
Explanation: The mapping between the board name entered and the slot
number for an adapter could not be established.
Action: Check the board name for the adapter before issuing the bind
command. If the problem remains, contact the network supplier.
Explanation: The number entered in the unbind command was not the
primary adapter in an AFT group.
Action: Reissue the unbind command and specify the slot number for the
primary adapter.
Explanation: The adapter that you specified could not be initialized.
Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and try loading the
AFT module again.
If the problem remains, contact the network supplier.
Explanation: The NetWare on the server is not a version supported by AFT.
Action: Load and bind AFT only on supported versions of NetWare (currently
version 5.1 and above).
Explanation: An unknown error has occurred when trying to allocate needed
resources for the AFT module.
Action: Check system configuration. If the problem remains, contact the
network supplier.
Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter driver.
Action: Unload the adapter driver before unloading the AFT module.