Table of Contents
Advertisement
v You can remove all power from the computer by disconnecting the server from
the ac power source.
Standby mode
When the server is connected to an ac power source but has not been turned on, it
is in Standby mode. When the server is in Standby mode, the operating system is
not running, and all core logic except for the service processor is shut down. The
power-on LED flashes to indicate that the server is in Standby mode. The server
can respond to requests from the service processor, such as a remote request to
turn on the server.
To put the server into Standby mode when the server is turned on, shut down the
operating system (see your operating-system documentation), and press the
power-control button.
The ISMP can also put the server into Standby mode. Additionally, if the server has
an optional Remote Supervisor Adapter installed or is connected to an ASM
interconnect network that contains at least one server with an optional Remote
Supervisor Adapter installed, you can also put the server into Standby mode
remotely through the Remote Supervisor Adapter user interface.
8
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
Advertisement
Table of Contents
Troubleshooting
