Updating The Server Configuration - IBM Eserver xSeries 335 Type 8676 Hardware Maintenance Manual And Troubleshooting Manual

illustration shows an ASM interconnect network with 46 servers.
Complete the following steps to cable an ASM interconnect network:
1. Follow the instructions for cabling a C2T chain.
2. Connect an ASM interconnect module (which comes with the Remote
3. Connect an ASM link cable (which comes with the Remote Supervisor Adapter)

Updating the server configuration

When you start the server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
starts so that you can save the new configuration information. See "Using the
Configuration/Setup Utility program" on page 10 for more information.
68
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
46
IN
25
IN
24
IN
23
IN
2
IN
1
IN
Supervisor Adapter) to the RS-485 connector on the Remote Supervisor Adapter
in the first server. If the network contains more than 23 servers, do the same on
the 24th server.
from the ASM interconnect module to the ISM connector in the first computer.
Insert a terminator into the second connector on the ASM interconnect module.
If the network contains more than 23 servers, do the same on the 24th server.
OUT
ISM
OUT
ISM
OUT
ISM
OUT ISM
OUT ISM
OUT ISM
Second
ASM bus
First
ASM bus