Table of Contents
Advertisement
Transmission interruptions
occur when listening to
internet radio stations.
Some internet radio stations
cannot be received
Bad sound quality at certain
internet radio stations
USB Storage device is not
recognised
or
Interruptions and / or jerky
reproduction of audio or
film material
80
Cause 1:
The capacity of the internet radio station's server is at its limit.
Remedy:
Choose a different station.
Cause 2:
Network problems occurred.
Remedy:
Check your network (see above).
Cause:
The internet radio station has been switched off, it transmits only at certain
hours of the day or it has changed its internet address.
Remedy:
Try to get information from the website of the station regarding transmission
hours an internet address (URL).
Try to establish a connection to the station at a later time.
Cause:
The station transmits with a low audio bandwidth (low bitrate).
Remedy:
Use stations transmitting at least at 128 kBit/s. This is the lowest recommended
bitrate for adequate sound quality. For good sound quality we recommend high
bitrates like 320 kBit/s
Cause 1:
The storage device (especially USB hard discs without separate power supply)
draws more electrical current from the USB interface than is permitted by the
USB standard.
Remedy:
Only use USB storage devices that conform to the USB standard or use
storage devices with own power supplies.
Cause 2:
The storage device is not formatted with an appropriate file system.
Remedy:
The K2 Blu accepts storage devices with FAT16 or FAT32 file systems.
Note:
For big music archives we recommend to use a NAS (network attached
storage) device with an UPnP-AV server to which the K2 Blu will connect via
your home network.
Cause 3:
The data transfer rate of the memory unit is too low, or the memory unit is not
compatible with the K2's USB port.
Remedy:
It is not possible to guarantee general compatibility with all devices on the
market due to the wide variety of USB memory media available.
If you encounter a persistent problem, we suggest that you try a different type
of USB memory unit.
Cause 4:
The USB memory unit is connected to the USB socket using a lead, rather than
directly.
Remedy:
Many USB extension leads are not suitable for the high data transfer rates
which occur during the Streaming process. Use only high-quality certified
cables, and ensure that the wire length is as short as possible (<50cm).
Advertisement
Table of Contents
