Table of Contents
Advertisement
Menu point
Sound delay
Menu point
Brightness
(Screen Brightness)
Menu point
Language
Menu point
Comfort standby
(Stand-by mode)
Menu point
Pair FD 100
18
Every video monitor requires a certain amount of time to display the video
signals (latency); this period may vary from monitor to monitor. If your monitor
has a long latency, the result may be a perceptible time-lag between the picture
and the sound. This is usually apparent when lip movements are not properly
synchronised with the soundtrack.
To compensate for this effect the K2 Blu features a digital sound delay module
(Lipsync) which can be used to synchronise picture and sound reproduction.
If necessary, set a delay time in this menu point which corresponds to your
video monitor. If the latency of your monitor is not stated in its Specification,
you will need to determine the appropriate value experimentally, e.g. by playing
a DVD in the original speech version (non-synchronised version). During
playback simply adjust the value for sound delay until the speaker's lip
movements coincide with the sound.
At this point you can adjust the brightness of the K2 Blu's integral screen to suit
your personal preference in normal use. Seven levels are available.
In this menu point it is possible to determine the language which is to be used for the
displays on the integral screen on the front panel of the K2 Blu.
The language used for any transferred data, e.g. from an iPod or an Internet
radio station, is determined by the device itself or the radio station, and
therefore cannot be selected on the K2 Blu.
The K2 Blu features two stand-by modes: ECO Standby with reduced stand-by
current drain, and Comfort Standby with additional functions, but slightly higher
current drain. You can select your preferred stand-by mode in this menu point:
Off (ECO Standby):
Active functions in ECO Standby mode: can be switched on by remote control
(except FD 100), alarm timer without Display.
On (Comfort-Standby):
The following expanded functions are available: Clock display, can be switched
on by remote control FD 100.
For information on energy-saving operation, and accurate information on
current drain in the various operating modes, please refer to the Chapter
entitled 'Economical use of energy' and the Specification in the Appendix
When you call up this menu point, the K2 Blu attempts to create a connection
with the K2 Blu radio remote control (see chapter 'FD 100 radio remote
control').
The FD 100, a graphic radio remote control handset with integral colour screen,
is designed to make the K2 Blu even more convenient to operate, and is
available as part of the accessory range. The K2 Blu is prepared for use
with the FD 100. (see chapter 'FD 100 radio remote control')
Advertisement
Table of Contents
