Table of Contents
Advertisement
Display category
Overview
Colour system
Resolution
40
Please select the 'Display' category if you wish to set the optimum values for
the video output.
Please set the video norm for your display device at this point.
NTSC: Video output at 60 Hz
PAL:
Video output at 50 Hz
Incorrect settings may result in a jerky and incorrect display.
At this point you should set the maximum resolution of the display device con-
nected to your system. For accurate information on the maximum resolution of
your display device please refer to the operating instructions supplied with the
unit.
The following resolutions are available:
Resolution Display devices e
HDMI auto The K2 Blu automatically selects the optimum setting for the
display device connected to the system.
This is the recommended setting, which should always be
used if possible.
You can try out one of the other settings to see if it suits your
television, but only if the AUTO setting causes picture problems
with your TV.
Your display device is capable of full HDTV resolution (full HD).
1080p
1080i
The display device connected to the system is a high-definition
device (HDTV) which can only be used at 1080i resolution.
The display device connected to the system is a high-definition
720p
device (HDTV) such as an LCD or Plasma flat screen designated
'HD-ready'.
576p
The display device connected to the system is a standard-
definition device which can also process progressive signals
(SDTV).
576i
The display device connected to the system is a standard-
definition device (SDTV) for NTSC / PAL (e.g. conventional CRT
television)
At any setting apart from AUTO you must also set the frame rate under "Colour
system" to match the disc in use.
PAL-DVD :=
PAL (50 Hz),
NTSC-DVD :=
NTSC (60 Hz)
Blu-ray :=
PAL or NTSC - according to the disc.
If you set the wrong frame rate, picture reproduction may be jerky.
Advertisement
Table of Contents
