Table of Contents
Advertisement
Menu point
Fader
Balance between loudspeaker
groups A and B
(The menu point only appears if
loudspeaker group B is connected,
and if two-room mode is switched
off in the System menu.)
Center
(This menu point only appears if
a Centre loudspeaker is
connected to the system)
Subwoofer
(This menu point only appears if
an external sub-woofer is
connected to the system, and is
switched on in the System Confi-
guration menu / Loudspeaker
menu.)
Sound (sound fields)
14
Adjustment range options:
-15 ... 0 ... +15
-15 ... 0 ... +15
-15 ... 0 ... +15
The following-setup options are intended for adjusting the reproduction of the
K2 Blu to suit the room acoustics.
Normal
Dynamic
Warm
Speech
Cinema
Explanation:
The Fader function is used to adjust the
balance between loudspeaker groups A and B,
if these are located in the same room.
If two-room mode is selected, this point is not
displayed, since in this mode the volume of
loudspeaker group B is controlled separately
using the external remote control receiver.
Menu point for adjusting Centre volume.
We recommend a setting at which the Centre
speaker fills the acoustic gap in the middle
between the main loudspeakers, but is not
quite detectable as a separate sound source.
This Menu point is used to adjust the volume
level of the sub-woofer.
Adjust the volume of the sub-woofer to suit the
acoustic conditions in the listening room, and
the volume of the other channels.
Linear,
musical
tone
enhancements;
recommended for normally damped listening
rooms.
Linear sound image with good dynamics and
precision
Particularly recommended for rooms with
severe damping, and loudspeakers which tend
to emphasise bass.
If you prefer a relaxed sound image with
slightly subdued treble, select the sound field
option Warm.
This option improves speech clarity in spoken
word programmes, documentaries and sports
transmissions.
Setting for use with cinema films, offering good
dialogue comprehensibility.
setting
with
no
Advertisement
Table of Contents
