Table of Contents
Advertisement
The Configuration for a WLAN connection
Setting the Parameters for a
Radio Network
Searching for and Selecting
the Network
Entering the Password
(for encoded networks)
Storing Network Settings
and Restarting
68
• Connect the WLAN aerial (supplied) to the K2 Blu WLAN aerial socket, and
ensure that no cable is attached to the K2 Blu LAN socket.
• Switch the K2 Blu on, and select the Streaming Client function by pressing
the
/
button.
• Now call up the Configuration menu as described above: with a long press on
the
button. You should now see the menu reproduced below, dis-
playing the network parameters.
First select the menu point 'WLAN configuration start', and activate it by
pressing the
button.
A menu appears showing these points:
• Rescan
- initiates new search for accessible radio networks
• Set manually - adding a WLAN manually
After a brief delay the networks present in the vicinity are listed on the screen.
You can use the 'Rescan' function to start a new search for networks present in
the vicinity.
Please select one of the networks located, and activate it by pressing the
button.
If your network is encoded, the window illustrated above now appears. Please
enter the network password and confirm the entry by pressing
select the point 'Save WLAN settings' and confirm with
If a WEP code is used, the password must be entered as a hexadecimal code
(0 - 9, A - F).
Please enter the settings for the remaining network parameters as described
earlier in the section entitled 'Setting the Parameters for a Wired Network'.
Finally select the menu point 'Save and Restart', and press the
this action accepts the settings, and restarts the K2 Blu with the new settings.
Possible entries
. Now
.
button;
Advertisement
Table of Contents
