T+A K2 Blu User Manual page 76

Sound:
The K2 Blu has
detected the Centre
loudspeaker or
loudspeakers connected to
output B. The associated
setup options in
loudspeaker configuration
menu and / or the tone
control menu are
displayed.
Loudspeaker group
cannot be switched on and
off using the remote control
handset in the main
listening room.
76
not Cause 1:
Loudspeaker cables not connected correctly.
the
Remedy:
Please check the loudspeaker leads for possible damage. Inspect the cable
terminals on the K2 Blu and the loudspeaker cabinets, and check that they are
the
making proper contact.
Cause 2:
The loudspeakers connected to the system are fitted with a capacitor in their
not
cross-over input (known as "high-pass filtered" loudspeakers).
Remedy:
A resistor (470 Ohm / 5 W) can be wired in parallel with the loudspeaker; this
will enable the K2 Blu to detect such speakers.
If you have queries about this, please contact your local specialist dealer, or
refer to the  Service on the e-mail address 'e-service@taelektroakustik.de'.
B Cause 1:
The "Two-room" mode of operation is set to "ON" in the System Configuration -
Loudspeaker settings.
Remedy:
In two-room mode, loudspeaker output B can only be controlled using the
remote control receiver in the adjacent room. Use the appropriate remote
control handset to control loudspeaker group B, or set two-room mode to
"OFF".
Cause 2:
The loudspeakers connected to the system are fitted with a capacitor in their
cross-over input (known as "high-pass filtered" loudspeakers).
Remedy:
A resistor (470 Ohm / 5 W) can be wired in parallel with the loudspeaker; this
will enable the K2 Blu to detect such speakers.
If you have queries about this, please contact your local specialist dealer, or
refer to the  Service on the e-mail address 'e-service@ta-hifi.com'.