Table of Contents
Advertisement
F i n a l I n s t a l l a t i o n
N o t e :
.
Step 2a
The rack door
has been
removed from
this graphic for
clarity of this
procedure.
Step 2:
Step 3:
Step 4:
Step 5:
6
Final Installation and Power Up
All 230 VAC DRd racks are shipped with a dimmer module retention bar installed.
The dimmer module retention bar prohibits installed modules from being removed
from the rack without the use of a tool.
Before installing modules into the rack, remove this dimmer module retention bar
from the left side of the enclosure (door hinge side). Complete the final installation
procedure outlined below, then
required to be installed in all 230 VAC DRd rack enclosures in order to maintain
proper CE rating.
Reconnect the three cable assemblies to the unit.
a: For the cable bundle on the left side, insert the connector into receptacle until
you hear a click.
b: For the ribbon cable on the right rear side; insert the connector into the
receptacle. Press gently on both sides until it clips into place.
c: For the two-wire cable on the right side, gently press the connector straight
into the receptacle. This connection is also keyed and can only install one
way.
Rotate the access panel closed, then slide the panel up approximately one inch
to align the panel to the captured screws.
Tighten the two captured screws, securing the access panel in place.
Install modules into the rack.
a: Align each dimmer module with the correct module slot and firmly press into
place. The face of the dimmer module should be flush with the DRd rack
enclosure.
b: Install the Station Power Module and Architectural Control Processor into
their respective slots. The Architectural Control Module (either SmartLink
ACP or Paradigm ACP) installs into the lowest module slot. The Station
Power Module installs into the slot directly above the ACP.
Engage Module Retention Bar
Step 3
Step 2.b
Step 2.c
Step 1:
Reinstall the Power Supply / Dimming
Engine Access Panel that was
removed prior to conduit installation
and wire termination.
a: Align the guide pins located on the
access panel to the guided slots
on the rack enclosure.
b: Glide the access panel down, so
that it rests fully into the guided
slots.
c: Tilt the supply access panel away
from the rack enclosure.
again. This bar is
53
Advertisement
Table of Contents
