Panasonic DMR-HS2 Operating Instructions Manual page 65

Numbered -
buttons
A, v, 4, b -
ENTER
SET UP -
I I
FUNCTIONS RETURN
Most of the DVD recorders and players manufactured by Panasonic
use the same remote control system. If you have more than one
piece of equipment placed in proximity to each other, they may all
respond to the signal. If this occurs, you will have to alter the code
on the unit as well as on the remote control (the two must match)
using the following procedure.
l
Use "I", the factory set code, under normal circumstances.
1
Press [SET UP] to show the menus.
2
3
4
5
Press [A, V] to select "Set Up" and
press [Fj.
6
Press [A, V] to select "Remote Con-
trol Code" and press [ENTER].
Press [A, V] to select the code (1, 2,
or 3) and press [ENTER].
The remote control code on the unit has been set.
While pressing [ENTER] on the
remote control, press the numbered
button ([I], [2] or [3]) corresponding
to the code you selected in step 4.
The remote control code on the remote control has been set.
Press [SET UP]
If the unit doesn't respond, you have entered the wrong code.
Repeat step 5 to enter the correct code.
The following display appears on the unit's display if its code and the
5
remote control's code are different. Change the remote control's
.;=
code to suit the unit. The display disappears after about 5 seconds.
2
The unit's remote control code
l
You can also set the unit's code without using the remote control.
(?J Press [FUNCTIONS] on the unit.
@ Press [A, V, 4, .] to select "SET UP" and press [ENTER].
GJ Carry out procedure 2-4 above.
@ Press [RETURN].