Panasonic DMR-HS2 Operating Instructions Manual page 62

Numbered
buttons
CANCEL
A, r 4, ä
ENTER
RETURN
See page 60 for menu and option details.
s -N
G
1
While stopped
iE
Press [SET UP] to show the menus.
Ttibs
Mews
Options
2 Press [A, V] to select the menu's tab
and press [FJ.
3 Press [A, V] to select the menu and
press [ENTER].
4 Press [A, V] to select the option and
press [ENTER].
The screen now shows the menu again.
l
Some items require different operations. Read the following
explanations.
The password screen is shown when you select levels 0 to 7.
1. Input a 4-digit password with the numbered buttons.
*If you enter a wrong number, press [CANCEL] to erase it.
2. Press IENTER].
@The lock symbol appears closed to show the rating is locked.
@Do not forget your password.
3. Press [ENTER] to confirm the 4 digits.
If you insert a DVD-Video that exceeds the ratings limit you set, a
message appears on the television.
Follow the on-screen instructions.
Change the settings when you have connected equipment through
this unit's DIGITAL AUDIO OUT terminal (+page 57,
q
).
Select the "Audio" tab and then "Digital Audio Output" by
following "Common procedures" (+ left) to set up "PCM Down
Conversion", "Dolby Digital" and "DTS".
PCM Down Conversion
Select how to output audio with a sampling frequency of 96 kHz.
Select "On" if the equipment you connect cannot process signals
with a sampling frequency of 96 kHz.
*Select "Off" if you use analog connect irrespective of the type of
equipment.
Off (Factory preset):
Output as 96 kHz. There is no output if the disc has copy protection.
Select "On" in this case.
On:
Converted to 48 kHz for output.
Dolby Digital and DTS
Bitstream (Factory preset for Dolby Digital):
Select if the equipment you connected can decode the signal
PCM:
Select if the equipment you connected cannot decode Dolby Digital
signal.
Off (Factory preset for DTS):
Select if the equipment you connected cannot decode DTS signal.
IMPORTANT
If the equipment you connected cannot decode the signal, the
setting must be changed to PCM or Off. If not, signals the
equipment cannot process will be output by this unit, causing
high levels of noise which can damage your hearing and the
speakers.
To return to the previous screen
Press [RETURN]+
When you are finished
Press [SET UP].