Panasonic DMR-HS2 Operating Instructions Manual page 13

Numbered
buttons
A, v', 4 b
ENTER
ADD/DLT
SET UP
A v,CH
RETURN
1
Press [SET UP] to show the menus.
2 Press [A, v] to select "Channel" and
press [,I.
3 Press [A, v] to select "Antenna Sys-
tem" and press [ENTER].
4
Press [A, v] to select "TV" or
"CATV" and press [ENTER].
TV:TV broadcast (2CH-69CH)
CATVCATV broadcast (lCH-125CH)
The screen shown in step 2 reappears.
5 Press [A, v] to select "Auto Channel
Setting" and press [ENTER].
If you have not yet set the clock, the "Auto Channel/Clock
Setting" screen appears.
6
Press [ENTER].
Auto setting starts. This takes a few minutes. (To stop auto
channel setting, press [RETURN].) When finished, the Com-
plete screen or time display is shown. Press [ENTER].
To return to the previous screen
Press [RETURN].
When you are finished
Press [SET UP].
While this unit is receiving the antenna signal (but not during
recording):
1
Press the numbered buttons to select
a channel.
e.g., "5": [0] 4 [5]
Units display
"15": [i] + [5]
"115": [loo] + [l] + [5]
l
You can also use [A v , CH] when you are going to delete a
channel.
2 Press [ADD/DLT].
The channel is deleted if it was set or added if it was not set.
e.g.,
Repeat steps 1 and 2 as necessary.