Setting The Time And Date - HySecurity SwingSmart DC 20 Installation And Reference Manual

User Menu

Setting the Time and Date

A feature of the Smart DC Controller is its 24-hour, 365 day clock. Make sure it is set to the appropriate time
zone. An accurate time and date allows the diagnostic log to date stamp operational data which indicates when
Alerts, Faults and Errors occur. The log helps in troubleshooting and can be viewed via a laptop connected to
the USB or RS232 port. For more information, refer to
To set or adjust the time or date, take the following steps:
1. At a gate status display, press the MENU button
twice. This accesses the User Menu and the
CLOSE TIMER display appears.
2. Press NEXT or PREV until the SET CLOCK
display appears.
3. Press SELECT.
CL blinks.
4. Press NEXT or PREV to change the number to 1.
5. Press SELECT to accept the display.
6. The date and time display appears. Use the
SELECT and NEXT buttons in the same
manner as before to adjust the date and time.
Note:A date or time field must be blinking before
it can be changed.
7. To accept what appears on the date and time
display, press SELECT.
8. To exit the User Menu, press the MENU
button. A gate status appears in the display
indicating you have returned to Run Mode.
Note:A lithium coin battery supports the clock so the
date and time is retained even when the main power is
turned off. Replace the battery about every five years
with a DL 2025, DL 2032 or CR 2025 or CR 2032
battery. Refer to Clock Battery
3-10 SwingSmart - Installation, Operation and Maintenance Manual
Replacement.
Smart DC Controller Troubleshooting.
HYSECURITY
GATE CLOSED
OPEN CLOSE STOP MENU
PREV NEXT SELECT
CT 0 (OFF)
CLOSE TIMER
OPEN CLOSE STOP MENU
NEXT SELECT
PREV
CL 1
SET CLOCK
OPEN CLOSE STOP MENU
PREV NEXT SELECT
01/05/01 00:00
^^
OPEN CLOSE STOP MENU
PREV NEXT SELECT
1. Start at a gate status
display.
RESET
2. To access the User
Menu, press the
MENU button twice.
RESET
3. Press NEXT until
the SET CLOCK
display appears. Use
the navigational
buttons to select 1.
RESET
4. Change the time
and date using the
NEXT and SELECT
buttons.
RESET
Revision A