Chapter 6: Reference - HySecurity SwingSmart DC 20 Installation And Reference Manual

This section of the manual provides information which may be useful when installing SwingSmart operators.
It includes how to:
• Connect a Radio Receiver for Remote Open
• Install a Gate Locking Mechanism
• Install a Solar-powered Operator (See NOTE.)
• Install Vehicle Detectors and Loops
• Install Photoelectric Sensors
• Install Gate Edge Sensors
• Troubleshoot error codes, faults, and hardware issues
• Diagnose vehicle detector and loop faults
• Review General Maintenance procedures
NOTE
Full installation instructions for the SwingSmart DC Solar operator are found in the solar
option package.
C
ONNECTING A
Take the following steps to mount a commercial
style 24VDC radio receiver (external antenna
type):
1. Install the receiver in the channel of the
chassis on either side of the electrical box.
2. Knock out the closest hole in the bottom of
the electrical box and route the wires to the
area marked RADIO OPTIONS. Only
three wire connections are needed because
the common wire and one radio output wire
are connected together Figure 6-1 shows
additional wires from a two channel receiver.
3. Make sure to observe polarity and crimp
together the black radio common wire and
one of the radio output wires using a ¼-inch
spade connector.
Revision A
R R
ADIO ECEIVER FOR
EDGE
EYE
COM
+ 24 V
EMERG
OPEN
Reference
R
SHOW
LEDs
R2
R1
Power
Two Channel Radio Receiver
Figure 6-1.
Chapter 6
O
EMOTE PEN
Shows connec ons
for Remote Open
and Gate Edge (dashed line).
6-1