HySecurity SwingSmart DC 20 Installation And Reference Manual page 76

Overview of the Smart DC Controller
PIN 2
PIN 1
Free Exit
Loop Detector
LOOP
Figure 4-4. Standard 11-Pin Box Type Vehicle Detector
V D
EHICLE ETECTOR
S
ELECTION
The Standard Quick Close modes are selectable in the Installer Menu. Refer to
The two selectable modes are described as follows:
Mode 1 (Default)
An input from either the Free Exit, Outside Obstruction Loop, Inside Obstruction Loop or the Center
Loop will hold the gate open, reset the close timer, and block all close inputs.
Mode 2
Same function as Mode 1, except the close timer can count to zero even with the Free Exit, Outside
Obstruction Loop, Inside Obstruction Loop or the Center Loop detector inputs active. If the close timer
has counted to zero, the gate will close when all detector inputs are clear.
4-8 SwingSmart - Installation, Operation and Maintenance Manual
Inside Outside
Obstruc on Obstruc on
Loop Detector Loop Detector
LOOP
IN OBS LOOP terminal
FREE EXIT LOOP terminal
C
ONFIGURATION AND
Center
Loop Detector
LOOP LOOP
Common
OUT OBS LOOP terminal
Q C
UICK
24VAC or 24VDC
Connect detector to match
its voltage rating
CENTER LOOP terminal
M
LOSE ODE
Table 3-2 on page 3-21.
Revision A