Hard Disk Connectors: Ide1/Ide2 - Acorp 7KT333 User Manual

Chaosdr 1 Chaosdr 1 Chaosdr 1 Chaosdr 1 Chaosdr 1
1.7.3 Floppy Disk Connector: FDC
This connector supports the provided floppy drive ribbon
cable. After connecting the single end to the board, connect
those two plugs on the other end to the floppy drives.

1.7.4 Hard Disk Connectors: IDE1/IDE2

These connectors support the provided IDE hard disk ribbon
cable. After connecting the single end to the board, connect
those two plugs at the other end to your hard disk.
If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumper settings. BIOS now
supports SCSI device or IDE CD-ROM boot up (see "HDD
Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS
Features Setup of the BIOS SOFTWARE) (Pin 20 is removed
to prevent inserting in the wrong orientation when using
ribbon cables with pin 20 plugged).
1.7.5 Fan Connectors: Fan1/2/3/4
USB1
COM1
Printer
COM2
Speak out
Line in
GAME1
MIC in
FAN 2/3
Connector
J3
FAN3
FAN2
FAN 1
Connector
AGP SLOT
FAN1
PCI1
PCI2
1
PCI3
PCI4
PCI5
PCI6
2
1
1 - 1 1 1 - 1 1
1 - 1 1 1 - 1 1 1 - 1 1
Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn Mnshdranarc Cdrbrhoshnn
VIA
JBAT1
8 7
BIOS
FAN 4
2 1
Connector
PANEL
SP-J2