Table of Contents
Advertisement
Chapter 1
1.7.3 Floppy Disk Connector: FDD
This connector supports the provided floppy drive ribbon
cable. After connecting the single end to the board, connect
the two plugs on the other end to the floppy drives.
1.7.4 Hard Disk Connectors: IDE1/IDE2
These connectors are provided with IDE hard disk ribbon
cable into the package . After connecting the end of cable
with single connector to the mainboard, connect the other
two connectors at the other end to your hard disk. If you
install two hard disks, you must configure the second drive
to Slave mode by setting its jumper settings. BIOS now
supports SCSI device or IDE CD-ROM boot up (see "HDD
Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS
Features Setup of the BIOS SOFTWARE).
1.7.5 Fan Connectors: FAN1~4
FAN1
Connector
VIA
VT610 5
FAN4
Connector
FAN 3
Connector
Intel
845GL
VIA
Intel
VT6306
ICH4
FAN2
Connector
1-18
Motherboard 4845GLQ
FAN1/2/3
Pin Definition
1
Sensor
1
2
+12VDC
2
3
3
Ground
FAN4
Pin Definition
1
Ground
1
2
+12VDC
2
3
3
N/A
Advertisement
Table of Contents
