Floppy Disk Connector: Fdd; Hard Disk Connectors: Ide1/Ide2; Fan Connectors: Fan1~3 - Acorp 4845GE Manual

Chapter 1

1.7.3 Floppy Disk Connector: FDD

This connector supports the provided floppy drive ribbon
cable. After connecting the single end to the board, connect
the two plugs on the other end to the floppy drives.

1.7.4 Hard Disk Connectors: IDE1/IDE2

These connectors are provided with IDE hard disk ribbon
cable into the package . After connecting the end of cable
with single connector to the mainboard, connect the other
two connectors at the other end to your hard disk. If you
install two hard disks, you must configure the second drive
to Slave mode by setting its jumper settings. BIOS now
supports SCSI device or IDE CD-ROM boot up (see "HDD
Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS
Features Setup of the BIOS SOFTWARE).

1.7.5 Fan Connectors: FAN1~3

Socket 478
Intel
845GE
FAN1
Connector
FAN1, FAN2 and FAN3 connectors
FAN2
Connector
Intel
ICH4
FAN 3
Connector
1-16
Motherboard 4845GE
FAN1/2 Pin Definition
1 Sensor
1
2 +12VDC
2
3
3 Ground
FAN3 Pin Definition
1 Ground
1
2 +12VDC
2
3
3 Ground