Removing The System Memory (Ram) - Clevo P650SE Service Manual

Disassembly

Removing the System Memory (RAM)

Figure 6
RAM-1 Module
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
Removal
DDR3L Up to 1600 MHz. The main memory can be expanded up to 32GB. The SO-DIMM modules supported are
1024MB and 2048MB DDR3L Modules. The total memory size is automatically detected by the POST routine once you
a. The RAM modules will
turn on your computer.
be visible at point 1 .
b. Remove the screws
Memory-1 Upgrade Process
and lift the shielding
plate out.
1. Turn off the computer, turn it over, remove the keyboard
2. The RAM modules will be visible at point
3. Remove screws
a.

Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module's
performance.

6. RAM Shielding Plate
• 4 Screws
2 - 10 Removing the System Memory (RAM)
after removing the shielding plate
1
- and lift the shielding plate
2 5
b.
1
(page 2 - 5).
(Figure 6a
off the computer (Figure 6b ) .
6
2
3
6
) .
5
4