Removing The Keyboard - Clevo P650SE Service Manual

Removing the Keyboard

1. Turn off the computer, turn it over.
2. Remove screws - from the bottom of the computer.
1 2
3. Open it up with the LCD on a flat surface before pressing at point
cial eject stick to do this) while releasing the keyboard in the direction of the arrow
4
4. Carefully lift the keyboard
6
board ribbon cable from the locking collar socket by using a flat-head screwdriver to pry the locking collar pins
7
away from the base (Figure
8
5. Carefully lift the keyboard
6
a.
3
1
2
3
4
up, being careful not to bend the keyboard ribbon cable
1b).
off the computer (Figure 1c).
b.
c.
5
to release the keyboard module (use the spe-
3
as shown
5
. Disconnect the key-
7
6
7
8
7
8 8
6
Disassembly
Figure 1
Keyboard Removal
a. Remove the screws from
the bottom of the compu-
(Figure 1a).
ter and then eject the
keyboard using a special
eject stick to push the
keyboard out while re-
leasing the keyboard as
shown.
b. Lift the keyboard up and
disconnect the keyboard
ribbon cable from the
locking collar socket.
c. Remove the keyboard.

Re-inserting the Key-
board
When re-inserting the
keyboard firstly, align the
keyboard tabs at the bot-
tom of the keyboard with
the slots in the case.

4. Eject Stick
6. Keyboard
• 2 Screws
Removing the Keyboard 2 - 5