Clevo P650SE Service Manual page 36

Disassembly
Memory-2 Upgrade Process
Figure 8
RAM-2 Module 1. Turn off the computer, turn it over, remove the battery
Removal 2. The RAM-2 modules will be visible at point
3. Gently pull the two release latches (
arrows
a. The RAM modules
will be visible at point
4. Pull the latches to release the second module if necessary.
1 on the main-
5. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
board.
6. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
b. Pull the release lat-
as it will go. DO NOT FORCE IT; it should fit without much pressure.
ches.
7. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
c. Remove the module.
8. Replace the bottom cover and the screws
9. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.

a.
Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module's performance.

4. RAM Module
2 - 12 Removing the System Memory (RAM)
&
2
(Figure 8b). The RAM module
1
(page 2 - 6).
on the mainboard (Figure 8a
1
) on the sides of the memory socket in the direction indicated by the
3
( )
will pop-up Figure 8c , and you can then remove it
4
(see )
page 2 - 6 .
b.
2
3
)
.
.
c.
2
4
3