Removing The System Memory (Ram) - Clevo ITAUTEC Service Manual

Removing the System Memory (RAM)

The computer has one memory socket for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDR3 1333/ 1066MHz. The main memory can be expanded up to 8GB. The SO-DIMM modules supported are 1GB,
2GB and 4GB and DDRIII Modules. The total memory size is automatically detected by the POST routine once you turn
on your computer.
Memory Upgrade Process
1. Turn off the computer, remove the battery
2. The RAM modules will be visible at point
3. Gently pull the two release latches on the sides of the memory socket.
4. The RAM module will pop-up
2
a.
1
5. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
6. The module's pin alignment will allow it to only fit one way. Make sure the module is seated as far into the slot as it
will go. DO NOT FORCE the module; it should fit without much pressure.
7. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
(page 2 - 5) and the component bay cover
on the main board .
1
(Figure 6b), and you can then remove it.
b.
(page 2 - 8).
2
Removing the System Memory (RAM) 2 - 9
Disassembly
Figure 5
RAM Module
Removal
a. Locate the memory
socket.
b. Remove the mod-
ule.

Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module's perfor-
mance.

2. RAM Module