Turning The Waypoint Mark On/Off; Displaying Navigation Data In Standby; Displaying Navigation Data - Furuno FR-7041R-MARK-2 Operator's Manual

1.29.2

Turning the waypoint mark on/off

The waypoint mark shows the waypoint position fed from the navigator. You can
turn this mark on or off as desired.
1. Press the [MENU] key.
2. Use the trackball to select OTHER MENU and press the [ENTER] key.
3. Use the trackball to select "10. WPT Mark."
4. Select Off or On as appropriate
5. Press the [ENTER] key.
6. Press the [MENU] key to close the menu.
1.30

Displaying Navigation Data in Standby

With connection of navigation equipment you can display navigation data in
standby. Below is a typical navigation data display in standby.
Speed
Depth
TO Waypoint bearing
Time-to-go to
TO Waypoint
Bearing to TO
Waypoint
Range to TO Waypoint
Note: Appropriate sensors
required to display data.
1.30.1 Displaying navigation data in standby
1. Press the [MENU] key.
2. Use the trackball to select OTHER MENU and press the [ENTER] key.
3. Use the trackball to select "14. STBY Disp" followed by Nav.
4. Press the [ENTER] key.
5. Press the [MENU] key to close the menu.
SPEED
10.5
kt
DEPTH
125
m
Heading
CRS 180.0
WPT TTG 01:08
BRG
RNG
N
OWN SHIP
LAT
LON 135˚00.00E
L
XTE
1.0 0.5
Figure 1-29 Typical navigation data display in standby
TRIP
ST-BY
000.3 nm
TEMPERATURE
+17.3
˚C
E
HDG
˚
092.5
˚
M
45.0 M
˚
12.0NM
S
30˚00.00N
Ship's position in
latitude and longitude
and Loran TDs
XTE
R 0.3NM
W
R
XTE
1.0
0.5
1. OPERATION
Standby or Timer
Trip distance since power on
Water temperature
Course
Cross Track Error
" " shows direction
and amount of error.
1-31