Dead Sector - Furuno FR-7041R-MARK-2 Operator's Manual

1. OPERATION
1.39

Dead Sector

If a dead sector (where no radar pulses are transmitted) is input at installation, it
may be shown on the display as below. The default setting is Off.
1. Press the [MENU] key to show the main menu.
2. Select OTHER MENU and press the [ENTER] key.
3. Choose "19. Dead Sector" and On or Off as appropriate.
4. Press the [ENTER] key followed by the [MENU] key to close the menu.
5. Press the [MENU] key to close the menu.
Dead sector
Figure 1-32 Dead sector
Note: Instructions for how to set a dead sector are contained in the installation
manual.
1-35