Advertisement
15. Locate the elevator control horn. Use a sharp hobby knife to remove the covering from
the elevator horn slot.
16. Glue the elevator horn in place with medium CA or epoxy. Make sure to scuff the
surface of the control horn before gluing.
17. Use a #11 blade to remove the covering from the elevator and rudder servo slots. Soak
the mounting area with thin CA. Install the servos using the manufacturer supplied
mounting hardware. You will need to attach a 24 inch servo extension to each servo
before installation. From the pilot's perspective, the elevator servo mounts in the left
rear side of the fuselage while the rudder servo mounts in the right rear side.
Advertisement
