Advertisement
3. Locate the composite aileron control horn, aileron pushrod, EZ connector, ball link, 2mm
bolt, nut and washer. Remove the covering over the mounting hole for the control horn with
your #11 blade. Scuff the part of the control horn that will glue into the aileron slot with fine
sandpaper. Glue the control horn in place with medium CA. Electronically center your
servo. Thread the ball link onto the pushrod and secure to the glass horn with the 2mm
screw, nut and washer as shown in the photo. Connect pushrod to servo arm with the EZ-
connector.
4. Repeat this procedure for the other wing.
That's it! You are done with the wings!
Advertisement
