Warning - Nikon ECLIPSE E200 MV Series Instruction Manual

WARNING

1. Do not disassemble.
Disassembling this product may result in electric shock or malfunction. Malfunctions and damage
due to such mishandlings will not be warranted. Do not disassemble any part that is not indicated
in this manual. If you experience problems with the product, contact your nearest Nikon
representative.
2. Read the instructions thoroughly.
To ensure safety, thoroughly read this manual and the manuals for other equipment to be used
with this product. In particular, be sure to follow the warnings and cautions at the beginning of the
manuals.
3. Input voltage
This product can be used with 100 to 240 V AC at 50/60 Hz, and can be used with most wall
outlets in the world. However, note that you avoid using the product under an environment where
the supply voltage may extremely fluctuate.
4. Use the specified lamp. (for E200 MV series only)
Use the specified lamp. Using an incorrect lamp may damage the product or cause a fire.
• Specified lamp
Halogen lamp 6 V-30 W (PHILIPS 5761)
5. Cautions on lamp replacement (for E200 MV series only)
• When replacing the lamp, wait approximately 30 minutes after turning off the lamp, and make
sure that the lamp and the field lens unit have cooled sufficiently.
• To prevent electric shock and product damage, turn off the power switch (press to the " "
position) and unplug the power cord from the wall outlet before replacing the lamp.
• When replacing the lamp, be sure that the lamp socket is not damaged. If it is damaged, it may
cause lamp failure or overheating. In addition, install the lamp into the lamp socket until it hits
the limit. If the lamp is not properly installed, it may fall off or cause overheating or smoke due
to mal-connection.
• After replacing the lamp, be sure to attach the field lens unit. Never use the product without the
field lens unit attached.
• Do not break the used lamp. It should be disposed of as an industrial waste, according to the
local regulations and rules.
6. Cautions on the power cord
Be sure to use provided (or specified) power cord. Use of other power cords may result in
malfunction or fire.
• See Chapter 10, "Specifications" for the specified power cord.
• To prevent electric shock, turn off the power switch (press to the " " position) before
connecting or disconnecting the power cord.
Note that this product is classified as Class I for electric shock protection. Be sure to connect it
•
to a protective earth terminal.
Safety Precautions
vi