Chapter 2 Switches And Controls - Nikon ECLIPSE E200 MV Series Instruction Manual

2
Switches and Controls
(1) Diopter ring
Adjust the diopter ring to
compensate for the difference
between your right and left
eyesight. (P.12)
(2) Revolving nosepiece
Can hold up to four objectives.
(3) Stage
(4) Specimen holder
Put your finger at the root or the
tip tilt of the claw to open the claw.
(P.10, 21, 31)
(5) Condenser aperture diaphragm
lever
Set the lever to match the
magnifying power of the objective.
(P.15)
(6) Condenser clamp screw
(7) Condenser auxiliary lens
Screw on to the bottom of the
condenser.
(8) Filter holder
The blue filter is provided for E200
MV series.
(9) Longitudinal stage motion
(Y Axis) knob
(10) Lateral stage motion (X Axis)
knob
These knobs are located either to
the right or the left of the stage.
(11) Field diaphragm ring
Set the ring to match the
magnifying power of the objective.
(P.18)
This ring is equipped only on the
microscope with a field diaphragm.
(12) Field diaphragm centering
screws
Used to center the field diaphragm
image. (P.14)
These screws are equipped only on
the microscope with a field
diaphragm.
(13) Fine focus knob
Used for fine focusing.
(14) Power switch
When pressed to the "l" position,
power is turned on and the lamp
lights.
When pressed to the "○" position,
power is turned off and the lamp
goes off.
(15) Brightness control dial
When turned clockwise, the lamp
voltage increases and the viewfield
becomes brighter.
When turned counterclockwise, the
lamp voltage decreases and the
viewfield becomes darker.
(16) Condenser focus knob
Use this knob when focusing the
field diaphragm image on the
specimen. (P.14)
The condenser focus knob is
located on the opposite side
depending on the model of he
microscope.
(17) Fine focus knob
Used for fine focusing.
(18) Coarse focus Knob
Used for coarse focusing.
The coarse focus knob is
located on the opposite
side of the stage motion
knobs.
(19) Coarse focus knob torque
adjustment ring
Used to adjust the tension (torque)
of the coarse focus knob. (P.24)
(20) Nameplate
Indicates the input voltage.
(21) AC inlet
Plug the power cord into this inlet.
Make sure that the power switch is
off (turned to " ") before plugging
the cord in.
4