Fujitsu PRIMEQUEST 2000 Series Message Reference page 116

Hide thumbs Also See for PRIMEQUEST 2000 Series:
Table of Contents

Advertisement

MMB Messages
13905
Adapter error(Entering read-only mode)
Meaning:
The adapter entered read-only mode.
Corrective action:
Replace the adapter.
Severity:
Warning
■SCSI common (Linux) related
14016
Device error (Error with sense data)
Meaning:
An error with sense data occurred in the device.
Corrective action:
Check the sense key of the original data to decide on the corrective action.
Medium Error: Perform cleaning. Replace the tape.
Illegal Request: Examine the software.
Data Protect: Check whether the media is write-protected.
Blank Check: A tape positioning error. Check operation.
Unit Attention: A reset occurred or the media was replaced. If there is a problem with the reset, examine the
HBA, transmission path, and target.
Aborted Command: An HBA, transmission path, or target failure may have occurred.
Other than above: Replace the drive.
Severity:
Warning
14018
Device error (Stepping over filemark forward failed)
Meaning:
A tape fast forward or rewind error occurred on the device.
Corrective action:
If normal operation cannot be restored even after cleaning and tape replacement, replace the drive.
Severity:
Warning
14020
Device error (Can't set default drive buffering mode)
Meaning:
A device error occurred. Changing the tape drive buffering mode (MODE_SELECT) failed.
Corrective action:
Check whether the tape device supports the buffer value contained in the message. If supported, a hardware
failure occurred. Replace the drive.
Severity:
Warning
14022
Device error (Error on write filemark)
Meaning:
A device error occurred. The write file mark command failed.
Corrective action:
If normal operation cannot be restored even after cleaning and tape replacement, replace the drive.
Severity:
Warning
14023
Device error (Can't set default compression)
Meaning:
A device or setting error occurred. The compression density could not be set to the default.
Corrective action:
If there is no problem with the settings of the backup software, replace the drive.
Severity:
Warning
101
CA92344-0540-06

Advertisement

Table of Contents
loading

Table of Contents