Fujitsu PRIMEQUEST 2000 Series Message Reference page 101

MMB Messages
12064
Adapter error (Suspect any fixed hardware failure)
Meaning:
An HBA reset was tried after a parity error was detected, but the operation ran out of retries. The HBA is
blocked.(PC error recovery)
Corrective action:
An HBA or a PCI bus in the system has a fault. Replace the adapter.
Severity:
Warning
12070
Adapter error (Adapter reset failed)
Meaning:
When a PCI error was detected, HBA Reset was executed, but it failed. (PC error recovery)
Corrective action:
The HBA must be replaced because it has a fault. Contact your sales representative or a field engineer.
Severity:
Warning
12078
Adapter error (bigger then rsp ring)
Meaning:
The index of the response ring on the port side is larger in value than the ring size.
Corrective action:
Driver firmware or hardware has a fault. Replace the adapter.
Severity:
Warning
12080
Adapter error (Unknown IOCB command Data)
Meaning:
An unknown IOCB command was detected (for a function for fast-path processing, with IOCB of a FCP ring
as the target).
Corrective action:
A driver or firmware has a fault. If the problem persists, replace the adapter.
Severity:
Warning
12081
Adapter error (Unknown IOCB command Data)
Meaning:
An unknown IOCB command was detected (for a function for slow-path processing, with IOCB of a non-FCP
ring (for example, ELS ring) as the target).
Corrective action:
A driver or firmware has a fault. If the problem persists, replace the adapter.
Severity:
Warning
12089
Adapter error (Adapter failed to mbxCmd CONFIG_HBQ)
Meaning:
Adapter initialization failure: The CONFIG_HBQ mailbox command failed.
Corrective action:
A card or the card firmware has a fault. Contact your sales representative or a field engineer.
Severity:
Warning
CA92344-0540-06
86